TOOLCRAFT LDM100H Bedienungsanleitung Seite 52

Maximum and minimum distance measurement
• In this mode, measurements are performed continually
with every beep.
• When a new maximum or minimum value is found, a pre-
cise measurement is performed.
New extreme values in the set of all measure-
ments replace the old maximum and minimum
values.
• The current measured value is always displayed in the
bottom-most line.
• Measured values are renewed at intervals of approx.
0.5 s.
• Holding the
urement. After 500 measurements, this measuring mode
will be left automatically.
Figure 5
Example
The distance from a narrow object such as a column should
be measured from a (larger) distance.
• Switch the device on via the
target the object to be measured.
52
(1)- MEAS button terminates the meas-
MIN
MAX
(1)- MEAS button and