YATO YT-82191 Bedienungsanleitung Seite 10

EN
below 70% without condensation. Do not expose the tool to precipitation.
Before connecting the tool to the power supply, make sure that the voltage, frequency and
performance of the mains correspond to the values shown on the tool's rating plate. The plug
must fi t into the socket. It is forbidden to modify the plug or socket in any manner to make
them fi t. The tool must be connected directly to a single mains socket. It is forbidden to use
extension cords, adapters or double sockets. The supply network circuit must be equipped
with a 16 A protection. Avoid contact of the power cord with sharp edges and hot objects and
surfaces. During operation, the power cord must always be fully extended and the position
of the power cord must be set so that it does not become an obstacle during operation. The
power cord should not be placed in a manner which would pose a risk of tripping. The mains
socket should be located in a place where it is always possible to quickly remove the tool's
power cord plug. Always pull the power cord by the plug housing when unplugging it, never
by the cord. If the power cord or the plug is damaged, immediately disconnect it from the
mains and contact an authorised service centre of the manufacturer for replacement. Do
not use the product with a damaged power cord or plug. The power cord or plug cannot be
repaired and must be replaced with a new one that is free of defects if these components
are damaged.
WARNING! The metal components of the tool can be hot during and immediately after use.
Do not touch them, as it may cause severe burns. Allow the tool components to cool down.
Use gloves which protect against high temperatures if you need to move these components
before they cool down. Make sure that the fl oor near the place of use of the tool is not slip-
pery. This will prevent slipping, which can cause serious injuries. Never block or restrict the
fl ow capacity of the air inlet openings. Do not use the tool in the bathroom or near water. Do
not touch the blade or blade holder as this can cause burns. After use, allow the product to
cool down completely before storing. Do not accelerate the process of self-cooling of the tool
components in any manner. Do not cool down the tool by putting it in water. This can cause
an electric shock. Materials should only be cut in well-ventilated areas.
EQUIPMENT INSTALLATION
CAUTION! Only install the accessories when the supply voltage is disconnected. Pull the tool power cord plug out of the mains
socket! If the blade needs to be replaced during operation, wait until the tool has cooled down completely. When the hot blade
needs to be cooled down do not place it on fl oors or fl ammable materials.
Blade installation (II)
Select a blade length suitable for the type of work to be carried out. Loosen all screws securing the blade. Slide the blade into the
gap between the blade holders. For the best possible cutting quality, the sharpened edge of the blade should point in the cutting
direction. Tighten all fi xing screws so that the blade does not come loose during operation.
PREPARING FOR WORK
Carry out a visual inspection, checking that the housing, blade and connecting cord with plug are not damaged before starting
work. If necessary, clean the tool of dirt and unclog the ventilation openings. It is forbidden to proceed with work in case of ob-
serving damage!
CAUTION! All activities related to preparation for work, connecting, etc. should be carried out with the power supply to the tool
switched off . Therefore, before proceeding: Pull the tool power cord plug out of the power socket!
Before using the tool, make sure that the mains parameters match the data on the rating plate.
O R I G I N A L I N S T R U C T I O N S
10