Configuration Settings; Activating The Hotkey Delay - G&D FIBREVision-MC4-ARU Installation Und Betrieb

Configuration settings

Activating the hotkey delay

Press the Hotkey+Backspace
onds to start the setup mode in the default settings. You can disable the hotkey delay
if you want to start the setup mode immediately after pressing the key combination.
How to (de)activate the hotkey delay:
1. Press Hotkey+Backspace
If the hotkey delay is active, press the key combination for seven seconds.
2. Press one of the setup keys listed below to (de)activate the hotkey delay:
7  activates the hotkey delay
 deactivates the hotkey delay
8
1. Use the terminal emulator to establish the connection to the FIBREVision
system.
2. Use the arrow
3. Press the Space
 activates the hotkey delay
Yes
No  deactivates the hotkey delay
4. Press the S key to save the settings.
(default: Ctrl+Backspace
(default: Ctrl+Backspace
keys to select the row
key (repeatedly) to (de)activate the hotkey delay:
) key combination for seven sec-
) to enable the setup mode.
Hotkey Delay .
G&D FIBREVision · 19
Configuration