Satel BE WAVE Smart HUB Plus Kurze Installationsanleitung Seite 8

8
Scan the QR code to go to our website and download the full manual of
the BE WAVE system controller.
Signs in this manual
Caution – information on the safety of users, devices, etc.
Note – suggestion or additional information.
Inside of the controller
Figure 2 shows the inside of the controller.
tamper protection.
power cable port.
lithium-ion rechargeable battery (3.6 V / 3200 mAh).
battery insulator pull tag.
SD memory card (factory-installed).
factory reset pinhole (insert a pin for 5 seconds).
button to enable the Wi-Fi access point mode (press and hold for 5 seconds).
LAN cable port.
SIM1 slot for first SIM card [Smart HUB Plus].
SIM2 slot for second SIM card [Smart HUB Plus].
Installation
The controller can be connected to a power outlet whose voltage is the same as the voltage
indicated on the controller's rating plate.
Do not connect the controller to a power outlet if the controller power cable or enclosure are
damaged.
Do not touch the power cable plug with wet hands.
Do not pull the cable to disconnect it from the outlet. Pull the plug instead.
If smoke is coming out of the device, disconnect the power cable from the outlet.
There is a danger of battery explosion when using a different battery than recommended by the
manufacturer, or handling the battery improperly.
Do not crush the battery, cut it or expose it to high temperatures (throw it into the fire, put it in
the oven, etc.).
Do not expose the battery to very low pressure due to the risk of battery explosion or leakage of
flammable liquid or gas.
If the controller is mounted higher than 2 m above the ground, it can become a danger when it
falls off the wall.
Do not place heavy objects on the controller.
Do not install the controller at locations above 2000 m above sea level.
The controller should be installed indoors, in spaces with normal air humidity. You can mount it on the wall or
place it on a tabletop. The place of installation should be close to a 230 VAC power outlet. The outlet must be
readily available. The electrical circuit must have suitable protection.
Smart HUB Plus ● Smart HUB
Quick installation guide
SATEL