Bosch BMCT-AMS Bedienungsanleitung Seite 14

Wall switch for smart actuators
Mounting
Step 1:
Step 2:
Step 3:
Now wire the cables from the consumer and the mains to the
corresponding terminals of the wall switch and actuator.
↑Contents
8-750-002-842 | V001 | 09/2024
Insert the desired actuator into the
holder on the rear of the switch (3)
(in this example, the light/shutter
control actuator).
Now wire the desired actuator
to the wall switch according to
the relevant wiring diagram in
the installation chapter. Use the
supplied cables.
The supplied cables are pre-cut at
the ends so that they can be easily
6 mm
stripped. They are cut at different
10 mm
lengths.
– 10 mm at wall switch terminals
– 6 mm at actuator terminals
English | 14
Bosch Smart Home