cecotec BOLERO DRESSCODE 10900 AUTODOSE INVERTER FULLCOLOR A Bedienungsanleitung Seite 127

You can use a soft brush to remove detergent residues adhering to the drawer.
Note: during the cleaning process, do not open the lid of the liquid detergent auto
dosing compartment, do not tilt, or turn the drawer to prevent the liquid detergent from
spilling out.
Note: do not operate the washing machine without the detergent drawer correctly
installed. When the washing machine is in operation, make sure that the drawer is
completely closed.
Cleaning the mesh filter in the water supply hose and the water inlet valve
1. Close the tap (stopcock) and unscrew the water supply hose (Fig. 19).
2. Carefully clean the mesh filter at the end of the hose with a fine brush (Fig. 20).
3. Now unscrew the water supply hose at the back of the appliance by hand. Remove
the mesh filter from the water inlet valve at the back of the appliance with needle-
nose pliers (be careful not to damage it) and clean it carefully (Fig. 21).
4. Reinsert the mesh filter back into the back of the washing machine. Reconnect the
water supply hose to the tap and to the appliance. Do not use a tool to connect the
inlet hose. Open the water tap and check that all connections are tight (Fig. 22).
Cleaning the drain pump filter
WARNING: DANGER OF BURNS. Danger of skin injury from hot water!
Take special care when draining water from the appliance and opening the lid.
It is advisable to clean the filter of the drain pump from time to time to ensure that there
are no problems.
The pump of the appliance may become blocked with loose debris (remember to check
the drum and remove visible debris after each load). Fabrics that shed large amounts of
lint can also cause blockages.
To access the drain pump filter, you must first open the cover on the bottom right-hand
side. Press lightly to open the lid (Fig. 23). With the lid open, proceed as follows:
1. If the appliance has not been drained, try draining it now. First, turn the washing
cycle knob to select the SPIN programme, press the SPEED icon until the display
shows "-", then press the START/PAUSE icon. Wait a moment for the pump to drain
the water from the drum. If the pump is totally blocked, the water will not be able
to drain, and the cycle will end.
2. Turn off the tap so that no more water enters. Switch off the appliance. Disconnect
the power cord from the plug.
3. Use the removable drain hose located on the filter access opening to drain the
BOLERO DRESSCODE 10900 AUTODOSE INVERTER FULLCOLOR A
BOLERO DRESSCODE 10900 AUTODOSE INVERTER FULLCOLOR STEEL A
BOLERO DRESSCODE 10900 AUTODOSE INVERTER FULLCOLOR ICE BLUE A
ENGLISH
127