Scheppach UMF1550 Original Bedienungsanleitung Seite 14

6. Technical data
Dimensions
Table height
Height of the side expansions
Spacing of the supports
min. / max
Max. permissible payload
Weight
7. Before starting the equipment
Check the device for transport damage. Immediately
report any damage to the transport company that de-
livered the device.
8. Attachment and operation
The universal machine stand is largely assembled and
you need only fit the handgrips and the workpiece sup-
ports as follows:
8.1 Erecting the universal machine stand
(fig. 3 - 4)
• Place the universal machine stand (A) on the floor
or on a workbench such that the frame legs (A.1)
point upwards.
• Press the spring pins (K) and fold out the frame leg.
• Once the spring pin latches into the intended posi-
tion, the frame leg is locked.
• Repeat this process for the other frame legs.
• Set the universal machine stand down on its feet.
8.2 Fit support arms (fig. 5)
• Fit the support arms (B) to the frame bed (A) by pull-
ing the locking lever (B.1) upwards to unlock it and
then latching the arm into place on the frame base,
firstly on the front side.
• Lower the rear side onto the bed and fasten the sup-
port arm in place on the frame bed by pressing the
locking lever (B.1).
Disassembly is carried out in reverse order.
14 | GB
935 - 1985 x 640 x
825 - 935 mm
780 mm
825 - 935 mm
935 - 1985 mm
150 kg
ca. 9.8 kg
www.scheppach.com
8.3 Fitting the workpiece supports (fig. 6 - 7)
• Insert the crossbar (C) into the receiver (L) of the
frame bed and fasten in place with the star-grip
screws (I).
• Insert the workpiece support (D) into the receiver
(M) of the crossbar and fasten in place with the star-
grip screws (J).
The width and height of the workpiece supports can be
adjusted with the star-grip screws (I,J).
8.4 Fastening your tabletop machine
Different tabletop machines can be fastened to your
universal machine stand by adjusting the support arms
(B) to the spacing of the mounting holes on your ma-
chine.
• Place your tabletop machine (e.g. mitre saw) on the
support arms (B).
• Fasten the tabletop machine with 4 hexagonal
screws (E), 4 washers (F), 4 spring washers (G) and
4 hexagonal nuts (H) on each of the support arms.
• Tighten the screws after assembly.
• Fasten the support arms (B) with the mounted tab-
letop machine on the universal machine stand, as
described in point 2.
8.5 Using the workpiece stops (fig. 8)
The workpiece supports (D) have integrated workpiece
stops (D.2), which can be used to saw multiple pieces
of wood to the same length.
• Loosen the star-grip screw (J) on the desired side of
the universal machine stand and adjust the height
of the workpiece support (D) such that the support
surface (D.2) is at the same height as the workpiece
support of the saw.
• Loosen the star-grip screw (I) to slide the workpiece
support horizontally.
• Set the desired distance between the saw blade and
the stop surface (D.1).
• Lock your setting by tightening the star-grip screws
(I) again.
9. Cleaning, maintenance and storage
m Important!
Before any cleaning or maintenance work, the electri-
cal tool fitted must be switched off and the mains plug
pulled out! Risk of injury!