Fittings; And Escape Door Function; Multi-Point Lock 319 With B-Function Without Escape Door Function; Multi-Point Lock 319 With E-Function - Assa Abloy 319E-2 Installationsanleitung Und Montageanleitung

Pic. 8 :
Fittings and door handles
Pic. 9 :
Key withdrawal position
EN
46

Fittings

Outside
Disengaged side
A
LA
2
XF
LA
A
max.
30°
Multi-point lock 319 with B-function and es-
cape door function
The multi-point lock 319 with B-function ("B-
function (changeover function)", page 33) and
escape door function requires a panic fitting
· with split handle pin and
· door handle supported in the escutcheons for
Panic side
The length of the handle pin depends on
· the door leaf thickness,
· the horizontal lock position, and
· the necessary depth of engagement in the door
I
LI
The inner and outer handle pin are different and
usually identified with embossed letters. The
screw-on part of the handle pin must be mounted
on the inside.
Multi-point lock 319 with B-function without
escape door function
The multi-point lock 319 with B-function
("B-function (changeover function)", page 33)
without escape door function with door handles
which can engage and disengage on both sides
XP
requires a continuous, non-split handle pin.

Multi-point lock 319 with E-function

The multi-point lock 319 with E-function
LI
("E-function (reversing function)", page 34) has a
continuous handle follower and requires a front
I
door fitting (outside with knob).

Lock cylinders

The length of the locking cylinder to be set is
determined from the door leaf thickness and the
inside and outside door plate thicknesses
(fittings).
The key withdrawal position (Pic. 9) of the locking
lever may not exceed 30° to the bottom left or
right.
max.
30°
rotation on both sides in accordance with DIN
EN 179.
handle (Pic. 8).
Installation