Werbung
Machine
Throttle trigger lever,
interlock lever
Test driving
6.2.2 Machine operating test
Action
Fit the battery inside its
housing (par. 7.2.3).
Activate the throttle trigger
lever. (without pressing
the throttle lock lever)
Press the throttle
lock lever and throttle
trigger lever.
Release the throttle
trigger lever.
6.3 START-UP
6.3.1 Start-up with battery
1. Remove the blade guard (Fig. 1.H) (if in use);
2. make sure the blade is not touching
the ground or any other object;
3. insert the battery correctly into its
housing (par. 12.B) (par. 7.2.3
4. press the safety button
5. Activate the throttle lock lever (Fig. 8.B)
and the throttle trigger lever (Fig. 8.A).
6.3.2 Start-up with battery
simulator (if provided)
1. Adopt a firm and well balanced position;
2. remove the blade guard
(Fig. 1.H) (if in use);
3. make sure the blade is not touching
the ground or any other object;
4. insert the battery simulator correctly into
its housing on the machine (Fig.12.J).
5. connect the connection cable to
the battery simulator (Fig.12.I)
6. select the battery to be operated
using the selector switch (Fig. 7.B)
7. press the safety button (Fig. 8.A)
8. Activate the throttle lock lever (Fig. 8.B)
and the throttle trigger lever. Fig. 8.A).
No signs of damage
or wear
The levers must move
freely and not be forced.
No abnormal vibrations.
No abnormal sound
Result
The blade should
not move
The throttle trigger lever
remains blocked.
The levers must move
freely and not be forced.
The blade moves.
The lever automatically
and rapidly returns to
the idle position.
The blade should stop.
;
)
Fig. 8.
;
(
C)
6.4 WORKING
Before you start cutting and trimming bushes
and hedges for the first time, it is advisable:
– to have been specifically trained
to use this type of equipment;
– to wear the harness correctly;
– to have carefully read the safety
regulations and user instructions
contained in this manual;
– to practise in order to get familiar
with the machine and the most
suitable cutting techniques.
To use the machine proceed as follows:
• always keep the machine connected to the
correctly worn harness when working (see
paragraph 6.1.3)
• The machine must always be firmly held in
both hands with the left hand on the front
hand grip and the right hand on the rear hand
grip, even if the operator is left-handed
Do not remove cut material or
hold material to be cut when blades
are moving. Make sure the machine
is off when removing cut material.
NOTE During use, the battery is
protected against total drainage with a
protective device that switches off the
machine and stops it from working.
6.4.1 Work techniques
It is recommended to trim the two vertical
sides of the hedge before trimming the top.
NOTE Battery power reserve (and
therefore the cuttable vegetation surface
before recharging is required) depends on
many factors described in (par. 7.2.1).
6.4.1.a
Vertical cutting
Proceed by cutting using curved movements
from the bottom towards the top, keeping the
blade as far from the body as possible (Fig. 13).
6.4.1.b
Horizontal cutting
The best results will be obtained with the
blade (Fig.14) slightly inclined (0° - 15°)
in the direction you are cutting, proceed
with a curved movement, slowly and
without interruptions, especially in the
case of very thick hedges (Fig. 14).
EN - 8
Werbung
