Werbung
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE HEDGE
TRIMMER DEVICE
Before assembling, make sure the
battery is not fitted in its housing.
• Insert the control rod (Fig. 3.A) in the
hedge trimmer device (Fig. 3.B).
• Slide the collar (Fig. 3.C) upwards and
turn it clockwise until it is fully tightened.
Periodically check that the
joints are well tightened.
4.3 EXTENSION OF THE HEDGE
TRIMMER DEVICE
• Loosen the knob (Fig. 4.A) following the
direction of the arrow - open padlock;
• pull or push the rod (Fig. 4.B) until
it reaches the desired length;
• when the adjustment is complete, tighten
the hand grip following the direction
of the arrow - closed padlock.
Periodically check that the
joints are well tightened.
4.4 REMOVING THE HEDGE
TRIMMER DEVICE
• To remove the hedge trimmer device
(Fig. 3.B), place the control rod (Fig. 3.A) on
the ground, loosen the collar (Fig. 3.C) and
disassemble the hedge trimmer device.
4.5 BATTERY BACKPACK
SETTING (IF PROVIDED)
The battery backpack comes already
assembled (Fig.1K) and can be
detached from the harness holder
(Fig. 5) and carried by hand.
To detach the battery pack, press
the two top buttons (Fig. 5.A).
The battery housings are located on
both sides of the backpack (Fig. 6)
On the right side of the backpack there are:
• cable socket (Fig. 7.A);
• a battery selector switch (Fig. 7.B);
• a USB port for charging other devices
(e.g. mobile phones) (Fig. 7.C).
In order to avoid the presence of loose
cables, there are slots positioned on
both sides and in the back, which can be
used to run the power cable through.
5. CONTROLS
5.1 SAFETY BUTTON (ACTIVATION
/ DEACTIVATION DEVICE)
Press this button to activate
and deactivate the machine's
electrical circuit (Fig. 8.C).
One LED on: the machine's
electrical circuit is activated.
The machine is ready for use.
Both leds on: the machine
is in action (Fig 8.D)
LED off: the electrical circuit
is completely deactivated.
IMPORTANT Do not keep
your finger on the button when
moving the machine to avoid
accidentally enabling the machine.
The "Warning" icon (Fig. 8.E)
lights up in case of mechanical
failure of the machine (see the
Troubleshooting table, par. 14).
EN - 6
Werbung
