Parkside PDM 600 C3 Originalbetriebsanleitung Seite 20

GB MT
General description
An illustration of the most im-
portant functional components
can be found on the front and
the back fold-out pages.
Scope of delivery
Carefully remove the device from the pa-
ckaging and check whether all the parts
listed below are present and complete:
• Lathe
• Face plate
• Tailstock
• Tool table
• 2 woodturning chisels
(1x flat/slanted, 1x hollow)
• 2 x open-ended spanners
• Mounting material:
- 8 mounting screws
• Instruction manual
Dispose of the packaging material
properly.
Overview
1 4-edge lathe point
2 Tool table
2.1 Screw, height adjustment
2.2 Bottom part of tool table
3 Guide rail
3.1 End piece of guide rail
4 Centring tip
5 Locknut
6 Tailstock
7 Handwheel
8 Lever, tailstock
9 Clamping lever, tool rest
10 On switch
11 Off switch
12 Speed regulator
20
13 Face plate
14 Woodturning chisel, flat/slanted
15 Woodturning chisel, hollow
16.1 Open-ended spanner, 17 mm
16.2 Open-ended spanner, 24 mm
17 Mounting screws
18 Drive shaft
19 Motor unit
Description of functions
The woodturning machine is intended for
processing wooden work-pieces. The clam-
ped workpieces can be rotated at three
different speeds.
Please refer to the descriptions below for
information on how the operating elements
work.
Technical data
Lathe ..........................PDM 600 C3
Rated voltage U ................... 230-240 V~
Rated frequency ............................50 Hz
Rated consumption
P ............................ 600 W (S6* 20%)
.................................550 W (S1**)
P
0
Idle speed
n ............................... 800-3000 min
0
Protection class .................................... II
Protection type .................................IPX0
Spindle head thread ................. M18x1.5
Weight .............................. approx. 6 kg
Max. workpiece length ...............600 mm
Max. workpiece diameter ...........250 mm
Sound pressure level
) ................... 84.8 dB(A); K
(L
pA
Sound power level (L
measured .......... 97.8 dB(A); K
* Operating mode S6 20%: Continuous operati-
on with intermittent load (cycle time 10 min). In
order not to heat the motor more than permitted,
= 3 dB
pA
)
WA
= 3 dB
WA
-1