ISE SY-7601 Bedienungsanleitung Seite 13

FIGURE 7: Install the Display and Tablet
Place the Display Holder (32) onto the
Handlebar Post (3). Then, unscrew the
Cross Recess Head Screw (33), fix the
display onto the Display Holder (32),
and secure it using Tool (B). Finally,
connect the sensor wire.
Start by installing the Tablet Stator
(37) into the Tablet (35) first. Align the
rear holes with the screw holes at the
top of the fixed tube extending from
the Handlebar Post (3). Next, use Tool
A to pass the Hex Flat Round Head
Screw (36) through the Tablet Stator
(37) and the Flat Washer (28), and
secure it with the Nylon Nut (38).
Finally, cover it with a plastic cap.
B
A
FIGURE 8: Install the Water Bottle Holder
Align the screw holes on the
Water Bottle Holder (24) with
the screw holes on the main
holder (1) (as shown). Then,
use Tool B to pass the Cross
Recessed Pan Head
Self-Tapping Locking Screw
(25) through the Washer (26)
and secure it in place.
ENGLISH
13.