Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.6 Troubleshooting
Malfunction
Engine does not start.
Unusual noises
Strong vibrations
Compressor switches on frequently.
Compressor runs without interruption / compres-
sor does not reach cut-off pressure.
4.7 Spare parts list for safety-critical applications
3 Oil sealing plug
4 Air filter
8 Drain plug for condensation
Safety valve
11
&
Quick coupling
12
14
4.8 Parts and consumables that need to be checked regularly and
replaced if necessary:
Pressure vessel
Drain plug for condensation water
Hose connections & quick couplings
Wheels and feet
Mains cable and mains plug
Safety valve
Air filter & filter elements
14
GB/IE/NI/CY/MT
Possible cause(s)
No or too low voltage.
Outdoor temperature too low.
Device is not switched on.
There is not enough oil in the pump system.
Extension cable is too long or too thin.
The motor has overheated. Overload switch
has been tripped.
Pneumatic connectors are loose.
Pneumatic connectors are loose.
Compressor is overloaded.
Too much condensation in the pressure vessel 5 . Empty the pressure vessel 5 regularly.
Air consumption for connected pneumatic tools
and devices is too high.
Quick couplings
&
leaking.
12
14
Pneumatic connectors leaking.
5. Disposal
The device, accessories and packaging* should be recycled in an environ-
mentally friendly manner.
The crossed-out dustbin indicates that the device must be collected separately
from unsorted municipal waste at the end of its service life.
Remedy
Make sure that the mains plug is inserted in the
socket. Check the fuse and replace it if necessary.
Check the mains voltage.
Ensure +5 °C ambient temperature.
Press the on/off switch
switch on the compressor.
Check the oil level and top up if necessary.
Replace the extension cable (min. 1.5 mm², max.
5 m long).
Allow the compressor to cool down and press the
23
overload switch
23
Check all connecting parts and tighten them
carefully if necessary.
Servicing and maintaining the compressor.
Observe the manufacturer's instructions for your
tool or equipment, especially with regard to the
amount of compressed air required.
Comply with the manufacturer's instructions for
your pneumatic tool, especially with regard to the
amount of compressed air required.
Check quick couplings
necessary.
Check pneumatic hose and tools, replace if
necessary.
This product is subject to the European Directive 2012/19/
EU. Do not dispose of the product in household waste, but via mu-
nicipal collection points for material recycling! Further information
on how to dispose of the discarded device can be obtained from
your local authority or city council.
to position "I", to
2
. Restart the compressor.
&
, replace if
12
14
Werbung
