Medion MD 11836 Bedienungsanleitung Seite 120

Cleaning the housing and foot pedal
Before cleaning, remove the plug from the mains socket.
Use a dry, soft cloth to clean the housing and foot pedal. Avoid the
use of chemical solutions and cleaning products because these may
damage the appliance surface or markings.
Cleaning the feeder
It is necessary to keep the fabric feeder teeth clean at all times to en-
sure perfect stitching.
• Remove the needle and sewing foot (see page 30 f.).
• Remove the screws on the needle plate (19) to remove the need-
le plate from the machine.
• Use a brush to remove dust and loose threads from the feeder
teeth.
• Replace the needle plate (19).
Cleaning and oiling the bobbin housing
• Move the needle to its highest position, otherwise the shuttle
cannot be removed.
• Remove the bobbin case.
• Turn the snap lever outwards as illustrated and remove the
shuttle track ring.
• Remove the shuttle by holding the pin in the centre of the shutt-
le.
• Remove all dirt from the shuttle track's ring and oil the parts
using a cloth.
• Put one or two drops of oil on the bobbin shuttle track, as illu-
strated.
• Now reassemble all the components following the instructions
in the reverse order.
EN
EN-33