AWG Turbo Strike 150 HP Originalbetriebsanleitung Seite 37

AWG | Nozzles | Turbo Strike
The flushing position can be noticed when the Turbo Strike rattles. Dirt
particles up to 4.5 mm diameter are rinsed out.
Perform multiple flushes if necessary.
Uncouple the Turbo Strike
1. When using foam concentrates, interrupt their supply.
2. Close the hand lever and the water supply.
3. Open the Turbo Strike to reduce the pressure.
Attention When you open the Turbo Strike, water comes out.
4. Disconnect the water hose from the coupling or thread of the Turbo
Strike (Fig. 2/6) according to the coupling system used.
Attention Water may emerge when the couplings are released.
5.3 Visual inspection after each use
The Turbo Strike is separated from the water supply.
9
The Turbo Strike must not be contaminated with foam agent. If neces-
9
sary, flush the Turbo Strike again as described in the previous section.
1. Check the Turbo Strike and, in particular, the toothed ring and the
valve plate on the nozzle head for visible damage.
Attention Do not continue to use damaged components!
2. Check that the hand lever as well as the adjusting sleeve and the
nozzle head of the Turbo Strike can be operated (unpressurised).
37
Flushing process during use
A flushing process may also be necessary during use if dirt
particles get into the Turbo Strike. This can be recognised
by an uneven, disturbed spray pattern.
In this case you can switch directly to the flushing position:
– Turn the adjusting sleeve into the flushing position and
flush it out for as long as necessary.
Attention: Only rinse if the situation in use allows it (obser-
ve self-protection).
If you discover any damage, this must be reported to the
person or department responsible.
uSE
M1148B10 | Rev. 01-07/24