Werbung
Verfügbare Sprachen
Verfügbare Sprachen
AWG | Nozzles | Turbo Strike
CAUTION
Attach adapters correctly
Danger of injury due to loosening of adapter connections.
– Always insert the adapters up to the stop and couple them fully.
IMPORTANT
Product information for foam concentrates
Observe the information on health hazards and potential environmen-
tal hazards (e.g. water hazard class) provided in the safety data sheet
and other product information for the foam concentrates used
Extinguishing in electrical installations / rated voltage up to 380 kV *
If the control distances according to DIN VDE 0132, Table 3: guideline
values H-5-10, are adhered to, a full jet of water from the Turbo Strike
in the highest flow position has sufficient resistance according to DIN
VDE 0132 to prevent a voltage flash-over at high voltages of up to 380 kV.
For low voltage up to 1 kV, the guide values N-1-5 must be observed.
* Test report of an accredited test laboratory according to
DIN EN ISO/IEC 17025 is available
33
Use of different foam concentrates
Note the compatibility of different foam concentrates with
each other.
Hand grip
The Turbo Strike nozzle can be operated without a handle
(description of assembly/disassembly in Chapter 7.2).
The function of the nozzle is not affected.
– Screw in a threaded pin as protection against contami-
nation.
uSE
M1148B10 | Rev. 01-07/24
Werbung
