Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Risk of leakage of batteries/rechargeable
batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries/
rechargeable batteries, e.g. radiators/direct
sunlight.
If batteries/rechargeable batteries have leaked,
avoid contact with skin, eyes and mucous mem-
branes with the chemicals! Flush immediately
the affected areas with fresh water and seek
medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries/re-
chargeable batteries can cause burns
on contact with the skin. Wear suitable protec-
tive gloves at all times if such an event occurs.
In the event of a leakage of batteries/recharge-
able batteries, immediately remove them from
the product to prevent damage.
Only use the same type of batteries/rechargeable
batteries. Do not mix used and new batteries/
rechargeable batteries.
Remove batteries/rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery/recharge-
able battery!
Insert batteries/rechargeable batteries according
to polarity marks (+) and (-) on the battery/
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery/rechargeable battery
and in the battery compartment before inserting!
Remove exhausted batteries/rechargeable bat-
teries from the product immediately.
Start-up
Note: Remove all packaging materials from the
product.
Inserting/replacing batteries
Loose the screw
10
compartment
.
1
and the clips
on battery
9
Open the battery compartment
two new batteries
For replacing battery, please remove exhausted
batteries first and then insert two new batteries
type AA (LR6).
Be sure the polarity is correct. This is indicated
in the battery compartment
Ensure gasket
being properly installed (see
11
Fig. C).
Close the battery compartment
clips
, then lock the screw
9
tightly (see Fig. C).
Setting up the product
Step 1
For HG11842A
Install the product in accordance with Fig A:
Fix the Halloween decoration
ing tube
to ground spike
5
For HG11842B
Install the product in accordance with Fig B:
Fix the Halloween decoration
tube
and extension tube
5
spike
.
7
Step 2
Insert the ground spike
ground (lawn, flower bed) for it to be stable.
Make sure you keep proper footing and balance
at all times.
Do not use any force when assembling or set-
ting-up the product, e.g. hammer blows. This
will damage the product.
Your product is ready for use.
Switching on and off
The battery compartment
button
.
2
Press this push button repeatedly to successively
set the product to TIMER, ON and OFF.
In timer mode the product glows permanently for
6 hours and will be followed by a subsequent
and insert
1
type AA (LR6).
8
.
1
and the
1
by screwing it
10
and support-
4
.
7
and supporting
4
to ground
6
far enough into the
7
has a push
1
GB/IE
15
Werbung
