Werbung
Figure 16. Removing the memory
Steps
1. Place the computer on its side with the left side facing up.
2. Carefully spread apart the securing-clips on each end of the memory-module slot.
3. Grasp the memory module near the securing clip, and then gently ease the memory module out of the memory-module slot.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch the
components or metallic contacts on the memory module as electrostatic discharge (ESD) can inflict severe damage
on the components. To read more about ESD protection, see
NOTE:
Repeat step 2 to step 3 to remove any other memory modules installed in your computer.
NOTE:
Note the slot and the orientation of the memory module in order to replace it in the correct slot.
NOTE:
If the memory module is difficult to remove, gently ease the memory module back and forth to remove it from the slot.
Installing the memory
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
Up to two memory modules may be installed into this computer.
The following image indicates the location of the memory and provides a visual representation of the installation procedure.
Entfernen und Installieren von vom Kunden austauschbaren Einheiten (CRUs)
ESD
protection.
37
Werbung
