DMX Calibration protocol:
DMX
1
Channel
Function
COL.
CALIBRATION
0 - 255
7
8
GOBOS
COLOURS
STROBO
STANDARD
STANDARD
STANDARD
PROTOCOL
PROTOCOL
PROTOCOL
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu
without reset by the "ArES" function) and use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the new adjusted positions of the colour, gobo, effect
and rot. gobo wheels and gobo indexing.
This message appears if you try to switch On the lamp within 5 minutes after having switched it Off (the lamp is
too hot). The message will come at the display if the lamp doesn´t ignite within 20 seconds. The SC-780 will store
this information and automatically ignite the lamp when the 5 minutes period has expired.
The ignition of the lamp is seven times unsuccessful (six times were appeared HEAt (message before), on the
display will appear "LAEr", meaning that the lamp could be damaged or even missed, the fixture is overheating
(can be occured if the ambient temperature is 55°C or more) or there could be a failure on the ignitor or ballast.
Please place or replace the lamp, check the ambient temperature or if the situation was not caused by the lamp
please, contact your dealer.
This messsage inform you that the main PCB does not communicate correctly with the control board.
(color wheel error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The color
wheel is not after the reset in the default position.
(static gobo wheel error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB).
The static gobo wheel is not after the reset in the default position.
(rotating gobo wheel error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB).
The rotating gobo wheel is not after the reset in the default position.
(rotating gobo indexing error) This messsage will appear after the reset of the fixture if the magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the
main PCB). The rotating gobo is not after the reset in the default position.
(effect wheel error) This messsage will appear after the reset of the fixture if the magnetic-indexing circuit malfunctions
(sensor failed or magnet missing) or the stepper motor is failed (or its driver circuit on the main PCB). The effect
wheel is not after the reset in the default position.
2
3
SGOB.
EFEC.
CALIBRATION
CALIBRATION
0 - 255
0 - 255
SMOOTH MICROSTEP MOVEMENT
9
10
PRISM
ROTATING
EFFECT
ROTATION
GOBOS
STANDARD
STANDARD
PROTOCOL
PROTOCOL
8. Error and Information messages
4
RGOB
ROTG
CALIBRATION
CALIBRATION
0 - 255
0 - 255
11
12
13
GOBO
IRIS
ROTATION
STANDARD
STANDARD
PROTOCOL
PROTOCOL
3 1
5
6
-
-
14
15
FOCUS
STROBO
STANDARD
STANDARD
PROTOCOL
PROTOCOL
16
DIMMER
STANDARD
PROTOCOL