Caution: At the last scanner, the DMX-cable has to be terminated with a 120
resistor. Solder the resistance
W
into a 3-pin XLR-plug and plug it in the DMX output of the last scanner.
The wires must not come into contact with each other, otherwise
the projectors will not work at all, or will not work properly.
4. Setup
4.1 Function of the control channels - 16 bit protocol
4.1.1 Channel 1 - Pan
Push slider up in order to move mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other
(0-255, 128-center). The mirror can be stopped at any position you
wish.
4.1.2 Channel 2 - Tilt
Push slider up in order to move mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other
(0-255, 128-center). The mirror can be stopped at any position you
wish.
2 3