Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Program brief description /
Program
sequence
Quick rinse cycle for lightly soiled dishes without drying
Main rinse (45°C)
Rapid
2x rinse (max. 45°C)
for dishes that are to be rinsed later in the day
Soak
Pre-rinse
½ Loading: switch on the function for a load of half or fewer place settings to be rinsed; energy and water con-
sumption are reduced. Add slightly less detergent than for a full load.
"Soak" programs!
Auto door opening: when the function is activated, the appliance door opens automatically at the end of the pro-
gram, which improves the drying results.
Notes on the ECO program
The ECO program is suitable for cleaning normally soiled dishes and is the most efficient program in terms of
combined energy and water consumption. The program is used to check compliance with EU legislation on
eco-design in accordance with DIN-EN 60436.
Informationen for the comparability test:
Capacity: 10 settings; Position of upper basket: lower position; Rinse aid setting: max; Softener setting: H3
The measurements are carried out under defined conditions (laboratory conditions).
Deviations in daily operation are possible.
General energy-saving tips
• Cleaning dishes in a household dishwasher generally uses less energy and water than washing by hand,
provided the dishwasher is used in accordance with the instructions.
• Loading the household dishwasher up to the specified capacity (fully loaded) helps to save energy and
water.
• Use the most suitable rinse program for the load in question.
• Do not carry out a pre-rinse (depending on the model) unless absolutely necessary.
• Manual pre-rinsing of the dishes leads to higher water and energy consumption! Do not pre-rinse the dish-
es under running water.
Starting a program
• The water supply must be opened to the maxi-
mum pressure.
• Load the dishwasher baskets.
• Fill in the detergent.
• Switch on the appliance.
• Set the required program options.
Detergent
pre / main (g)
12
(or tab)
-
Function not available for the "Rapid" and "Soak" programs!
• Start the operation.
Changing the program
CAUTION:
A program change should only be done a short time
after the program start. Otherwise, cleaning agent
may already have been released and rinsing water
already drained off.
37
Time
Energy
(min)
(kWh)
30
0.560
15
0.115
Function not available for the "Rapid" and
Water
Rinse
(l)
aid
￮
9.6
￮
3.4
Werbung
