Tesmed Max 830 Gebrauchsanweisungen Seite 42

Beep: deactivating the beep
To deactivate the beep, press and hold the buttons
simultaneously for 2 seconds, the display will show the
message "BEEP OFF" (fig. 3). Repeat the operation to
reactivate the beep; the display will show the message
"BEEP ON" (fig. 4) and the device will play a beep sound.
Switching off the device
To switch off, press and hold the button for 3 seconds
Tesmed Max 830 will switch off automatically if left unused for more than 5 minutes in order to save
the battery.
Disconnecting the electrodes
Once treatment is complete,
disconnect the plugs from
the cables as shown in figure 2,
taking care not to damage
the cables.
Accidental activation block for travel
With the device off, press and hold both the buttons
show the Tesmed logo, the key symbol and the remaining battery
cedure is recommended when the device is kept in a suitcase or bag to avoid accidental activation.
To unlock, briefly press the buttons
When this function is active, a small amount of energy is consumed which, after a few days, may
completely drain the battery. It is therefore recommended to check the remaining charge every now
and then via the icon
In accordance with the law, total or partial reproduction is forbidden. Feldi srl - Italy - www.tesmed.com
2
and again.
MODE MODE
which is always visible.
- 42 -
3
whatever the state of the device.
and for 2.5 seconds. The display will
MODE MODE
4
. This pro-