Werbung
Mounting of PLUS FAN
7.Connect the harness terminals (3 types) of the upper and lower assemblies of PLUS FAN
respectively, and connect the anode and cathode of the power cord.
DE
EN
IT
ES
The wiring harness shall be neat, and all terminals shall be connected firmly without any
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
cable ties after wiring harness arrangement.
FR
8.Place the spring and the transmission square shaft into the manual knob groove of the
PLUS FAN in turn.
The wiring harness shall be neat, and all terminals shall be connected firmly without any
NL
insufficient or omitted connection. The wiring harness shall be aligned in color, and fixed with
Drive square shaft
cable ties after wiring harness arrangement.
8.Place the spring and the transmission square shaft into the manual knob groove of the
Spring
PLUS FAN in turn.
FI
Hand knob
DK
SE
Mounting of PLUS FAN
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
9.After arranging the wire harness, align the square shaft with the corresponding position
and the square shaft shall be clean and free from oil stain and other sundries.
The spring shall be free from damage, the handle shall rotate flexibly without stagnation,
of the upper assembly of the top cover, insert the lower assembly of the interior trim
and the square shaft shall be clean and free from oil stain and other sundries.
frame of the PLUS FAN , and screw the ST3.9×40 cross pan-head screws (4 pcs) into the
16
16
corresponding holes in turn.
Harness shall be neat and all terminals shall be connected firmly without insufficient or
Harness shall be neat and all terminals shall be connected
omitted connection. Screws shall be fixed firmly.
firmly without insufficient or missing connection. Screws
10.Insert the lamp covers laterally into the corresponding slots in the lower assembly of
shall be fixed firmly.
the PLUS FAN trim frame.
CARBEST VanVent | 318028/318029
6.
Connect the three connectors
of the outdoor unit to the cor-
responding counterparts of the
indoor unit. The power cable
(red/black) must be connected
to the vehicle's 12 V electrical
system.
7.
Place the spring and the drive
square shaft into the manual
knob of the VanVent. Please
choose the suitable drive
square shaft according to the
roof thickness:
Drive square shaft 120mm
suitable wall thickness:
27-47mm
Drive square shaft 140mm
suitable wall thickness:
48-67mm
Drive square shaft 160mm
suitable wall thickness:
68-80mm
8.
After placing the wiring harness,
align the square shaft with
the corresponding position of
outdoor unit, and screw the
ST3.9×40 cross head screws
(4 pcs.) into the corresponding
holes one by one.
22
Werbung
