Bresser 7803510 Bedienungsanleitung Seite 25

ACTIVATING ALARM AND TEMPERATURE PRE-ALARM FUNCTION
1 . In normal mode, press [ ALARM ] key to show the alarm time for 5 seconds .
2 . When the alarm time displays, press [ ALARM ] key again to activate the alarm function .
Or press [ ALARM ] key twice to activate the alarm with ice pre-alarm function .
Alarm off
NOTE:
Once the ice pre-alert activated, the alarm will sound 30 minutes earlier if it detects outside
temperature is below -3°C .
When clock reach the alarm time, alarm sound will start .
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in
the next day .
- By pressing [ALARM / SNOOZE] key to enter snooze that the alarm will sound again after 5
minutes .
- By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will
activate again in the next day
- By pressing [ ALARM ] key to stop the alarm and the alarm will activate again in the next day .
NOTE:
- The snooze could be used continuously in 24 hours .
- During the snooze, the alarm icon "
TEMPERATURE / HUMIDITY FUNCTION
- The temperature and humidity reading are display on the outdoor and indoor (CH) section .
- Use the [ °C / °F ] slide switch to select the temperature display unit .
- If temperature / humidity is below the measurement range, the reading will show "Lo" . If
temperature / humidity is above the measurement range, the reading will show "HI" .
COMFORT INDICATION
The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level .
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity .
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F) .
WIRELESS SENSOR SIGNAL RECEIVING
1 . The console display signal strength for the wireless sensor(s), as per table below:
Outdoor 7-in-1 sensor
Indoor channel sensor
2 . If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear . The temperature and humidity will display "Er" for the corresponding channel .
3 . If the signal does not recover within 48 hours, the "Er" display will become permanent . You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again .
Alarm on
" will keep flashing.
Too cold
No signal Weak signal
20
Alarm with ice-alert
Comfortable Too hot
Good signal
GB