Herunterladen Diese Seite drucken

Bosch CRR 320 Originalbetriebsanleitung Seite 43

Vorschau ausblenden Andere Handbücher für CRR 320:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Drawing points
Check the box to interpolate a curve over the points.
If no check mark is set, the individual points are con-
nected by lines.
Interpolation
Check the box to interpolate a curve over the points.
If the box in unchecked, the individual points are con-
nected by lines.
Torque limit values
If this option is selected, the torque limit values of the
preset or the screwing parameter with which the curve
was recorded are shown in the graph. The OK range is
displayed as a green corridor.
Angle limit values
If this option is selected, the angle limit values of the
preset or the screwing parameter with which the curve
was recorded are shown in the graphic. The OK range is
displayed as a green corridor. In combination with the
torque limit values option, the OK range is displayed as
a green window.
Automatic angle scaling
If automatic angle scaling is activated, the displayed
range of the X-axis is based on the largest angle value
actually measured. Otherwise, the set angle limit values
are used to determine the displayed range.
Printing
Print the current curve view.
Closing
Close the curve window.
Robert Bosch GmbH
Work Schedule Editor | CRR 320 | 43 |
23.11 Selecting points
Points on the curve can be selected. By marking a
point, perpendiculars are drawn from the point onto
both axes. The measured values are displayed at the
point itself. There are two ways to select a point:
#
Clicking:
$
Click on the corresponding point in the drawing
#
Context menu:
$
Select a pair of values in the table
$
Right-click to open the context menu
$
Click on select point
This way, only points with a white background can
be selected. Points with a white background are cur-
rently displayed in the diagram. Measured values with
a gray background are not drawn in the current interval
display.
23.12 Removing the selections
Markings can be removed again in the context menu of
the value table.
#
Remove a point selection:
$
Select a pair of values in the table
$
Right-click to open the context menu
$
Click on remove selection
#
Remove all point selections:
$
Right-click on the value table to open the context
menu
$
Click on remove all selections
en
|
0 986 629 502
2024-03-24

Werbung

loading