Bosch CRR 320 Originalbetriebsanleitung Seite 30

en | 30 | CRR 320 | Torque measurement with limit value specification (Md)
The or navigation buttons can be used to in-
crease or decrease a value or change the measurement
direction.
The or navigation buttons (right or left) are
used to navigate to the individual items.
Use the or navigation buttons to display the
programmed values.
The or navigation buttons are needed to
switch to the main menu.
|
0 986 629 502 2024-03-24
10. Menu item: Work schedule
Use the or navigation buttons to switch to
the main menu. Select the "Work schedule" menu item
from the main menu with the
buttons.
Confirm your selection with the
Fig. 6: Menu item Work schedule
The first screw connection of the work schedule is
shown in the display!
Use the or navigation buttons to switch to
the next screwing parameters (only for "manual" work
schedule).
The abort button can be used to switch to the main
menu.
When creating a work schedule using the software, it
can be determined whether a work schedule should be
completed "manually" or "automatically".
i
A work schedule is a combination of multiple screw-
ing parameters (e.g, pre-tightening, loosening, final
tightening). These screwing parameters contain all
information on a screw connection (e.g., min./max.
values, measurement direction, angle, ...). In the cur-
rent version, the CRR 320 can store a maximum of
5 screwing parameters in a work schedule.
c
The programming of the screwing parameters can
only be carried out using the software included in
the scope of delivery.
10.1 Manual work schedule
If a work schedule is created "manually" and saved in
the CRR 320, it is now possible to select between the
individual screwing parameters using the
navigation buttons.
There is no fixed sequence that must be adhered to. Se-
lection of the desired screwing parameter is confirmed
using the confirmation button.
Use the or navigation buttons to display the
programmed values.
or navigation
confirmation button.
or
Robert Bosch GmbH