Makita JV001GZ Betriebsanleitung Seite 6

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Length of stroke
Strokes per minute
Blade type
Max. cutting capacities
Overall length (with BL4025)
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for the sawing of wood, plastic and
metal materials.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-11:
Sound pressure level (L
Sound power level (L ) : 98 dB (A)
WA
Uncertainty (K) : 3 dB (A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Wood
Mild steel
Aluminum
) : 90 dB (A)
pA
D.C. 36 V - 40 V max
BL4020 / BL4025 / BL4040 / BL4040F
DC40RA / DC40RB / DC40RC / DC40WA
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-11:
Work mode: cutting boards
Vibration emission (a
Uncertainty (K) : 2.5 m/s
Work mode: cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
6 ENGLISH
JV001G
26 mm
-1
800 - 3,500 min
B type
135 mm
10 mm
20 mm
283 mm
2.6 - 2.9 kg
2
) : 4.6 m/s
h,B
2
2
) : 4.8 m/s
h,M
2