Safety Information; Installation - Fluval Sea PS1 Bedienungsanleitung

SAFETY INFORMATION

ATTENTION: please verify that all components of the skimmer are undamaged before putting it into function. ALWAYS disconnect
electrical supply of the skimmer and any other appliance placed in the water before performing any maintenance. Be sure that the
voltage of the mains supply corresponds to the voltage shown on the unit's label.
• The pump is intended for indoor use only in water with a maximum temperature of 35° C (95° F).
• DO NOT RUN DRY - Do not connect to electrical supply if pump is not completely immersed in water.
• Do not connect to electrical supply if pump is missing parts.
• The cord of this pump cannot be replaced or repaired; in case of damage the entire unit must be discarded.
• Do not cut or pull on the electrical cord.
• Always disconnect from main power supply gently and make sure hands are dry.
• To avoid any danger of electric shock remember to always keep all connections dry.
• Verify that the main power supply is clean, and is not humid or encrusted with salt deposits.
• Please keep these instructions in a safe and dry place for future reference.

INSTALLATION

The Fluval Sea Protein Skimmer is designed to be positioned inside
an aquarium or sump filter by using the suction cups (A) or the mounting bracket (B).
In Aquarium
Choose where to position the skimmer inside your aquarium. Remember to clean
the aquarium surface carefully so the suction cups will adhere to the glass properly.
When using the mounting bracket, the suction cups can be removed from the
suction cup pins.
• Position the skimmer so that the water level is in between the
minimum/maximum water levels to guarantee adequate surface aspiration (C).
• Position the Collection Cup by adjusting the O-ring.
• Connect the skimmer to the electrical supply.
In Sump
If the sump does not not offer a min. 25.4 cm (10 inch) water level a suitable glass or plastic box may be placed in the sump that does.
The skimmer may be mounted within this box with water supplied by either a dedicated small submersible pump or the incoming
drainage water from the display aquarium. The box can then be allowed to naturally overflow into the sump. This type of installation
will also provide a constant water level for the skimmer.*
The following instructions on regulating water level and airflow are only indicative for the start up of the skimmer. It will then be up
to you to adjust the system to better fit your aquarium.
IMPORTANT: The skimmer needs to run at least three to seven days before it starts foaming properly and the setting becomes final.
It is possible to notice some air bubbles entering the aquarium through the drainage. This is normal and these bubbles will disappear
once the skimmer reaches its operating balance.
*Rolf C Hagen Inc. assumes no liability for this type of installation in regards to water leaks, splashing or other unforeseen
mishaps as it is the full responsibility of the purchaser to ensure a safe and secure installation of this nature.
A B
C
Max.
Min.