Toshiba MMU-AP0091H Betriebsanleitung Seite 22

High Wall Type
• Push the projection at the center of air filter. Clip is out.
• Undo the clip of air filter, pull the air filter downward while
pushing it toward the main unit side.
Floor Standing Cabinet Type
• Push down the upper part of the suction port a little,
and then pull toward you to remove it.
• Take out the air filter inside of the suction port.
Floor Standing Concealed Type
• Push down hook of the air filter on the front panel
(Lower side).
• Pull the air filter toward you to remove it.
Floor Standing Type
Removal / Attachment of air filter
• Pull the air filter toward you.
• To attach the air filter, insert it into the main body and push in it.
• For cleaning of air filter, use a cleaner or brush clean. If stain is heavy,
it is effective to wash the air filter in tepid water mixed with neutral detergent.
• After washing, rinse it well, and dry it in the shade.
• Install again the air filter which has been cleaned.
Cleaning of main unit / remote controller
• Wipe them with soft and dry cloth.
• A cloth dampened with cold water may be used on the indoor
unit if it is very dirty.
• Never use a damp cloth on the main unit and remote controller.
• Do not use a chemically-treated duster for wiping or leave such
materials on the unit for long. It may damage or fade the sur-
face of the unit.
• Do not use benzine, thinner, polishing powder, or similar sol-
vents for cleaning. These may cause the plastic surface to
crack or deform.
NOTE
CAUTION
Polishing
powder
19
Push the air filter,
and pull it downward.
Front panel
(Lower)
Air filter knob
Thinner
Benzene
Chemical
Do not use.
floor-cloth