Chauvet Professional MAVERICKMK2WASH Bedienungsanleitung Seite 43

Operation
Operating Settings Configuration
Home Screen
The Maverick MK2 Wash has a home screen that shows the current control protocols, personalities,
starting addresses, IP addresses, and universes. To see the home screen, press <MENU> repeatedly until
it shows on the display. From the home screen, touch any of the displayed control settings to immediately
jump to that part of the menu (e.g., the personality, starting address, or universe) or press <ENTER> to
reach the main menu.
Test Mode
Auto test
To perform an auto test of the Maverick MK2 Wash functions, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Test Mode, or touch the display where it
says Test Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Auto test, or touch the display where it says Auto test.
5. Press <ENTER>.
Manual test
To test the functions of the product manually, do the following:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Test Mode, or touch the display where it
says Test Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Manual Test, or touch the display where it says Manual Test.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP> or <DOWN> to select the function to test, or touch the display where it says the desired
function.
7. If using the buttons instead of the touchscreen, press <ENTER>.
8. Change the value of the tested function with one of the following methods:
• Type the desired value using the number pad that shows on the touchscreen display.
• Use <UP>, <RIGHT>, <DOWN>, or <LEFT> to increase or decrease the value from 000–255.
9. Press <ENTER>.
Setup
To reach the Setup menu, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Setup, or touch the display where it says
Setup.
3. If using the buttons instead of the touchscreen, press <ENTER>.
Network settings
To reach the Network Settings menu, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Network Settings, or touch the display where it says Network
Settings.
3. If using the buttons instead of the touchscreen, press <ENTER>.
IP mode
The IP address of the Maverick MK2 Wash can be set manually, by the network, or to a preset static
address specific to each product. To set the IP Mode, follow the instructions below:
1. Navigate to the Network settings
2. Use <UP> or <DOWN> to select IP Mode, or touch the display where it says IP Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from:
• Manual (set the IP address with the control panel)
• DHCP (the network sets the IP address)
• Static (a preset address specific to each product), or touch the display where it says the desired
mode
5. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 15
Home Screen
Home Screen
Home Screen
menu.
menu.
shows on the display. Press <ENTER>.
shows on the display. Press <ENTER>.
shows on the display. Press <ENTER>.
Page 28 of 197