Descaling Procedure - Küppersbusch EKDG6551.0 Bedienungsanweisung Mit Montageanweisungen

EN
Care and maintenance

Descaling procedure

Warning: For safety reasons, the descaling
process cannot be interrupted and it takes
about 45 minutes.
The appliance must be in idle state prior to
starting the descaling cycle.
To run a descaling cycle proceed as follows:
1. Press the "On/Off" key  to switch the
oven on.
2. Press the "-"  and "OK"  keys at the
same time for 5 seconds. The display shows
"CAL". If you wish to cancel the descale
process at this stage Press the "On/Off" key
.
3. Press the "OK" key  to start the descaling
function.
4. When the display shows "0.5L", Short beeps
are emitted. Remove the water tank.
5. Pour 0,5 litres of an adequate descaling
solution into the water tank and put the
water tank back.
6. Press the "OK" key . The Descale cycle is
initiated and takes about 30 minutes.
69
The descaling process is silent and during
this process the display shows continuously
"0.5L" (without blinking).
7. When the display shows "1.0L" flashing and
the oven emits a beep, remove and empty
the water tank.
8. Fill the water tank with 1,0 litres of cold
water and put the water tank back.
9. Press the "OK" key . The first rinsing
cycle starts.
10- When the display shows again "1.0L"
flashing and the oven emits a new beep,
remove and empty the water tank.
11. Fill the water tank with 1.0 litres of cold
water and put the water tank back.
12. Press the "OK" key . The second rinsing
cycle starts.
13. When the rinsing cycle has finished the
display shows "End".
14. Remove, empty and dry the water tank.
15. Press the "OK" key  to finish the
process.