Basic Settings - Küppersbusch EKDG6551.0 Bedienungsanweisung Mit Montageanweisungen

Basic settings

Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock, the
water hardness parameter and the Calibration is
set.
Setting the clock
The clock display will flash if your appliance is first plugged in or after a power failure, to indicate that the
time shown is not correct. To set the clock, proceed as follows:
To set the clock, proceed as follows:
Press the "On/Off" key  to switch the
1.
oven on.
Press the "Time function" key.
2.
(Step 1 and 2 can be skipped if the device
3.
is connected for the first time, or after a
power failure).
Press the "–" and "+" keys to select the
4.
function.
Water Hardness setting
The appliance features
automatically indicates when it is time to descale.
The system can be optimized for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range
of water hardness (see table below).
To set the water hardness parameter, proceed as
follows:
Press the "On/Off"  key to switch the
1.
oven on.
a system that
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
Press the OK key , to confirm.
5.
Press the "-" and "+" keys  to set the
6.
hours.
Press the OK key  to confirm the hours.
7.
The minutes digits will flash.
Press the "-" and "+" keys  to set the
8.
minutes.
Press the OK key  to confirm the
9.
minutes.
Press the "+" and "OK"  keys
2.
simultaneously. The Water Hardness level
will start to flash on the display.
(Steps 1 and 2 are not necessary if the
oven is first plugged in or after a power
failure.)
Press the "–" and "+"  keys to select
3.
the desired water hardness according to
the table below.
Press the "OK" key  to set the
4.
parameter. The oven returns to the "ON"
state.
EN
44