exquisit GS581-051C Gebrauchsanweisung Seite 27

What to do if the refrigeration circuit is damaged:
Avoid naked flames and ignition sources.
•
Ventilate the room in which the appliance is installed thoroughly.
•
Contact After Sales Service.
•
Se ng up and connec ng
10
Before setting up and connecting the appliance, ensure that
the appliance is disconnected from the mains power supply (see residual risks
•
chapter) and
the installation conditions are fulfilled (see chapter Minimum Clearances).
•
Unpacking the appliance
The packaging materials must be undamaged. Inspect the appliance for transport
damage. On no account should a damaged appliance be connected to the mains power
supply. In case of damage, contact the supplier.
CAUTION
RISK OF INJURY AND APPLIANCE DAMAGE!
Always carry out transport with a second person.
•
Do not cut packaging material with a sharp object, e.g. carpet knife.
•
Removing transport protection
The appliance and some of the interior parts are secured for transport.
Remove all adhesive tape on the right and left side of the appliance door.
•
Remove styrofoam parts above the compressor on the rear of the unit, if present.
•
Remove all adhesive tapes and packaging parts from the interior of the appliance.
•
Remove residues of adhesive with alkaline water.
•
There may be stickers with warnings on the appliance. These must be observed and not
removed from the appliance.
10.1 Changing the door stop / fi ng the door handle
The door hinge of the appliance can be shifted from left to right or vice versa.
ATTENTION
APPLIANCE DAMAGE!
Do not tilt the appliance more than 45° when mounting the door in order not to damage
the refrigerating system.
Tools required for changing door hinges:
DESIGNATION
Cross-head screwdriver
Flat screwdriver
Page 27 of 41
Setting up and connecting
TOOL