First Camera Access - Abus TVIP41550 Bedienungsanleitung

Connecting the camera by using a router / switch
1. Make sure to use a pair of patch cables
2. Connect the cable with Ethernet port of the PC / laptop with the router / switch.
3. Connect the cable with the network cable and with the router / switch.
4. Connect the power supply to the camera
5. If there is a name server (DHCP) available in your network then set the IP address of your PC /
laptop to "automatically receive IP address"
6. If there is no name server (DHCP) available set the IP address of your PC / laptop to 169.254.0.1
7. Continue with point 5.1 in order to finish the initial installing and build-up a connection to the
camera.

4.1 First camera access

The first camera access takes place by using the program „Installation Wizard 2".
After starting the wizard it will automatically search the network for all connected EyeseoIP network cameras
and cameras.
You can find the program on the on the CD at
CD-ROM\Tools\EyseoIP Tools\
Install the program on your PC and start it. The
wizard will automatically search your network
for EyseoIP camera.
The IP address at factory default is
169.254.0.99. Without using the installation
wizard you can only connect to the camera if
the IP address of the PC is between
169.254.0.1 and 169.254.0.98.
If a DHCP server is active in your network the
IP address for your PC and camera will be set
automatically.
Start now the installation wizard. If no DHCP
server is active the installation wizard adds a
virtual IP address in the range of 169.254.0.xx.
As long as the installation wizard is active you
can access the network camera by using the
virtual IP address. We recommend adjusting immediately the cameras network settings to the IP settings of
the PC's network.
After closing Installation wizard 2 the additional virtual IP adress will be removed. If IP-
Camera's IP address is still in a different IP area then the one from your PC the camera access
Internet
Patch cable
70
English