Led Status Display; Initial Start-Up - Abus TVIP41550 Bedienungsanleitung

3.2 LED status display

Status LED description:
Status / LED colour
System start
Camera turned off
Network works (heartbeat)
Network problem
Firmware update
Restoring factory settings
In order to reboot the camera or restore the factory settings press the reset button. Use an appropriate small
tool.
Camera reboot: Press the reset button once and wait until the camera to restart.
Restore factory settings: Press and hold the reset button for approx. 30 seconds until the status LEDs start
flashing. All settings will be reset to factory default.

4. Initial start-up

Direct connection between camera and PC / laptop
1. Make sure to use a crossover network cable
2. Connect the cable with the Ethernet port of the PC / Laptop and the camera
3. Connect the power supply to the camera
4. Configure the IP address of the PC / Laptop to 169.254.0.1
5. Continue with point 4.1 in order to finish the initial installing and build-up a connection to the
camera
Green Red
Off On
Off Off
1/s On
Off On
1/s 0.1/s
Off 0.1/s
 Crossed Ethernet cable
69
English