Midea M6 Bedienungsanleitung Seite 20

INSTALLATION
Installation of side brush
„ Installation of side brush
1. By ensuring the side brush has
a consistent color with that of
its slot,directly push the side
brush into the slot, and a "click"
sound indicates complete
installation;
„ Machine charging
1. Remove the strip seal according to prompt texts on the machine;
2. By aligning the machine to the charging dock in the indicated direction, push the machine into the charging
dock in order for charging.
1. When the main unit gets contact with the charging dock, the power indicator flashes to indicate the main unit
is charging;
2. If the main unit fails to charge, check whether the charging chips of the machine at the bottom are blocked by
hair bundles of the side brush on two sides. Manually turn the side brush to eliminate possible blockage.
„ Instructions prior to use
1. Prior to startup, clean up scattered wires and debris on the floor, and remove objects that are easy to fall,
fragile, valued, and possibly result in hazards. Prevent from being entangled, stuck, dragged, or knocked down
by the main unit, resulting in damages to people and property;
2. If overhead structures exist in the cleaning area, secure and block them with appropriate objects to prevent
damages to people and property due to their possible falling;
3. Recommend following the robot throughout the initial cleaning to assist in dealing with some possible small
problems. After these problems are solved, the robot will smoothly carry out its automatic cleaning in the
future. If no cleaning is required or the robot may be trapped in some special areas, it is possible to add
exclusion zones or virtual walls at corresponding positions in the map shown in the App, in order to prevent the
robot from entering these areas.
16
2. When disassembly is required,
use two hands to hold the
rubber-covered leg of the side
brush (take care of not pulling its
hair bundle forcibly) to remove it
by keeping the machine bottom
facing upwards.
Notes