STEINEL Universal Actuator UA6 KNX-S Bedienungsanleitung Seite 21

Universal Actuator
Press button Ǖ (6) briefly.
￭
LED Ǖ (7) flashes, LEDs A1... (4) of the first configured output or output pair
flash.
Short-time manual operation is switched on.
After 5 s without a button actuation, the actuator returns automatically to bus
operation.
Switching off temporary manual operation mode
The device is in short-term manual mode.
￭ No button-press for 5 s.
- or -
Press Ǖ (6) button briefly as many time as necessary until the actuator
￭
leaves the short-time manual mode.
Status LEDs A1... (4) no longer flash, but rather indicate the relay status.
Short-time manual operation is switched off.
Switching outputs: depending on the programming, the output relays switch to
the position that is active after the manual mode is switched off, e.g. logic
function.
Venetian blind outputs: depending on the programming, the blind moves to the
position that is active after the manual mode is switched off, e.g. to safety or
sun protection position.
Switching on permanent manual operation mode
Operation is not disabled.
Press the Ǖ (6) button for at least 5 s.
￭
LED Ǖ (7) lights up, LEDs A1... (4) of the first configured output or output
pair flash.
Continuous manual mode is switched on.
Switching off permanent manual operation mode
The device is in permanent manual operation mode.
Press the Ǖ (6) button for at least 5 s.
￭
LED Ǖ (7) is off.
Continuous manual mode is switched off. Bus operation is switched on.
Switching outputs: depending on the programming, the output relays switch to
the position that is active after the manual mode is switched off, e.g. logic
function.
82402638 7 / 14 21.11.2023