Maintaining The Product; Changing Batteries - testo 175 Bedienungsanleitung

4. Hold [Go]
- The display shows
175 T2, testo 175 T3, testo 175 H1).
- The yellow LED lights during the copying process.
- The green LED flashes twice and after the copying
process the display shows OUT.
5. Remove the SD card.
6. Insert the SD card into the SD card slot on the PC.
7. Process the read out data, see separate operating
instructions testo ComSoft.
Pos: 38 /TD/Überschriften/7. Produkt instand halten @ 0\mod_1173789831362_79.doc @ 397 @ 1
8

Maintaining the product

Pos: 39 /TD/Produkt instand halten/testo 175/Batterien wechseln @ 6\mod_1275474943888_79.doc @ 62277 @

8.1. Changing batteries

The battery change stops the currently running
measurement program. However, stored
measurement data are preserved.
1. Read out stored measurement data, see Reading out
measurement data, page 52.
✓ If it is no longer possible to read out the saved
measurement data because the battery capacity is too
low:
> Change the batteries and read out the stored
measurement data after.
2. Place the data logger on its front.
3. Loosen the screws on the back of the data logger.
4. Remove the battery compartment cover.
depressed for longer than 2 seconds.
CPY
8 Maintaining the product
(testo 175 T1) or COPY (testo
53