Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EnglisH
8
To treat your back, place the appliance beside a chair or stool, with the lamp housing in vertical
,
position, and sit down comfortably with your back towards the appliance (Fig. 10).
Place the appliance beside a chair, with the lamp housing in horizontal position, and sit down
,
comfortably to treat the hip and upper leg area. (Fig. 11)
Adjust the lamp housing
Turn the height adjustment ring to the left, pull the lamp housing up or push it down to the
,
desired height and then lock it into position by turning the ring to the right (Fig. 1).
To tilt the lamp housing upwards or downwards, grasp it by its handgrips and move it to the
,
desired position (Fig. 1).
You can also turn the lamp housing to horizontal or vertical position by grasping it by the
,
handgrips and turning it to the required position (Fig. 1).
Make sure the pedestal base is horizontal. If it is placed at an angle, the appliance will switch off
,
automatically (Fig. 15).
Sit or lie down at the right distance from the appliance.
-
At a distance of 40-50 cm to the body, the InfraCare treats an area of about 40 cm by 60 cm.
At a larger distance, the area treated becomes larger and the infrared light and therefore the
warmth less intense. At a smaller distance, the area treated is smaller and the infrared light and
therefore the warmth more intense.
-
Make sure the distance between your body and the appliance is large enough to prevent
accidental contact with the hot filter.
-
Choose a distance at which the heat is comfortable.
Note:The warmth of the appliance does not reach its full intensity until several minutes after switching
the appliance on. This does not mean, however, that the appliance is not effective during these first
minutes.
Duration of treatment
The duration of the treatment depends on the person to be treated and the type of use. We
recommend a few short treatments a day, e.g. 2 treatments of 15 minutes, on a number of
consecutive days to get a result.
Note:Practice has shown that a few short treatments a day produce a better result than one longer
treatment.
Always consult your doctor in case of doubt!
using the infracare
1
Insert the plug into a wall socket.
The on/off button (a) and the timer buttons (d) blink for 1 minute, the maximum intensity
,
button (b) lights up and 00 blinks on the display. (Fig. 16)
Set the desired treatment time by pressing the + or - timer button. Keep the button pressed
to adjust the time more quickly.
Adjust the light intensity of the lamp by pressing one of the intensity buttons. If you do not
press any of these buttons, the lamp will operate at its default setting, which is maximum
intensity.
Switch the appliance on by pressing the on/off button.
5
If you want to interrupt the treatment, press the pause button (C) (Fig. 16).
The lamp goes out, but the remaining treatment time is stored in the memory of the appliance.
-
To resume the treatment, press the pause button again.
6
To change the treatment time and light intensity during the treatment:
Werbung
