90 electrolux
Programme
P6
Quick
P7
Prewash
The pressure and temperature of the
water, the variations of power supply
Care and cleaning
Warning! Switch the appliance off
before you clean the filters.
Cleaning the filters
Caution! Do not use the appliance
without the filters. Make sure that the
installation of the filters is correct.
Incorrect installation will cause
unsatisfactory washing results and
damage to the appliance.
If necessary, clean the filters. Dirty filters de-
crease the washing results.
The dishwasher has two filters:
1. coarse filter (1)
2. fine filter (2)
Make a check of the coarse filter after
each washing programme.
Make a check of the fine filter at regular
intervals.
Coarse filter (1)
1. Open the door.
2. Remove the lower basket.
3. Remove the coarse filter, clean it fully un-
der running water.
4. Put back in position the coarse filter.
Fine filter (2)
1. Open the door and remove the lower
basket.
2. Hold the fine filter by the handle.
Duration (in minutes)
30
7
Energy (in kWh)
0,9
0,1
and the quantity of dishes can change
these values.
3. To remove the fine filter, turn the handle
to the right.
4. Clean the fine filter fully with a brush under
running water.
5. Put the fine filter back in position.
6. To lock the fine filter system, turn the han-
dle to the left. Make sure that the signs on
the filter agree with each other.
Cleaning the spray arms
At regular intervals make sure that the
nozzles in the spray arms are not
blocked. If necessary, clean the nozzles
with a piece of wire or a needle under
running water.
Water (in litres)
8
4