Franke Maris Water Hub Installations- Und Benutzerhandbuch Seite 6

EN
Safety instructions must be observed
in order to avoid physical injury and/or
damage to the product and/or system.
Maintenance instructions must be
observed in order to avoid damage and
excessive wear.
As a result of the ongoing
improvement of our products and/or
systems, illustrations in this document may
differ from the appliance as delivered.
If available, you can download the
latest version of the manual via our website:
www.franke.com
Franke cannot be held responsible for
costs, damage or personal injury if the
product is not operated in accordance with
the instructions given in this manual.
Tap and boiler model may differ from
the model illustrated in the manual.
Tap
Avoid burns and scalding and pay
attention when using hot water. The
temperature of the hot water may be higher
than 55°C.
Avoid burns and scalding and pay
attention when using boiling water. The
temperature of the water may be higher
than 100°C.
Tiled and stone sinks will not withstand
boiling water; the difference in temperature
can cause these to crack. Always open the
cold water tap when pouring out boiling
water and preferably pour the boiling water
directly into the drain.
Boiler
Before commissioning, ensure that the
boiler is filled with water.
Never pick up or carry the boiler with
the hoses or the mains lead.
The appliance must be connected
always with the cold water supply.
Before installation of the boiler make
sure the pressure relieve valve outlet is 8 cm
above the connection of the waste pipe.
The drain hose must be connected
with a continuous downwards gradient and
a siphon must be made, therefore please
note you may need to cut the drain hose.
Filter cartridge
The use of a Franke filter is mandatory
to protect the product against lime scale
deposits. It is mandatory to change the filter
based on the water hardness table.
After storage at a temperature of 0°C,
the filter must first be stored for 24 hours at
room temperature before it is installed.
The filter cartridge must not be
opened or damaged.
The filter cartridge and the system
must be intensively flushed after a
prolonged standstill period and/or during
maintenance work (2 liters of flushing water
after 1 week standstill; 10 liters of flushing
water after 4 weeks' standstill).
The filter cartridge must be replaced if,
after commissioning, it has not been in
operation for 3 months.
Warranty
Scan the QR code to reach
the Warranty guidelines:
6