Connection To The Gas Supply; Installing The Ceramic Logs; Access To The Burner Unit (For Maintenance Or Repairs) - Dovre 750 GA Einbauanleitung Und Gebrauchsanweisung

1.3 Connection to the gas supply

Check whether the gas type and the gas pressure correspond to the indications on the
identification plate.
An approved AGB/BGV gas valve must be fitted as close as possible to the appliance.
The connection must be tension-free.
Check that the gas supply pipe has no leaks (e.g. using soapy water).
For pipes up to +/- 10 m in length, 3/8" G tubes or 10/12 diameter copper tubes are
adequate. For more than 10 m use 1/2" or 13/15 diameter copper tubes.

1.4 Installing the ceramic logs

Unlock the door.
The ceramic logs are packaged separately. Be careful, as the logs are very fragile.
Position the logs as indicated on the plan.
Installing the ceramic blocks

1.5 Access to the burner unit (for maintenance or repairs)

Proceed as follows:
Open the front door and remove the ceramic blocks. You can now unscrew the (M6)
screws from the burner box.
750GA(P): Remove the rear heat shield. Remove the right side panel (side of the control
block) by unscrewing the screw in the side panel and then removing the hinge pins. The
mounting plate of the control block can now be unscrewed (2 x M6).
Remove the thermal switch holder (TTB) by unscrewing the two self-tapping screws on
the back plate. Do not forget to remove the thermostat sensor from its holders.
You can now pull the complete burner unit (control block and burner) out of the back of the
appliance.
To refit the burner unit reverse the order of the steps above.
18 wijzigingen op grond van technische verbeteringen voorbehouden