Holmatro CT 5150 Betriebsanleitung Seite 49

8.5.8 Blades
See Fig. 12.
• Check the blades for damage. Have a Holmatro Certified Technician replace the blades when they
are damaged or the blade tips are damaged or worn.
• Check whether the blades are straight. Have a Holmatro Certified Technician replace the blades if
there is more than 0.6 mm (C) separation.
8.5.9 Centre bolt
See Fig. 12
• Check that the tightening torque of the centre bolt (B) is 50 Nm.
• Spray Teflon lubricating oil on and between the moving parts of the centre bolt (B) while the tool is
opening and closing.
CAUTION
The centre bolt may not be removed. Contact a Holmatro Certified Technician.
8.5.10 Hinge pins
See Fig. 12.
• Spray Teflon lubricating oil on and between the moving parts of the hinge pins (A) while the tool is
opening and closing.
WARNING
The hinge pins may not be removed.
8.5.11 Snap rings of hinge pins
See Fig. 12.
• Check that the snap rings of the hinge pins (A) are present and are not damaged.
Have a Holmatro Certified Technician mount a new snap ring if it is missing or damaged.
8.5.12 Spreading tips
• Check the spreading tips for damage. Have the Holmatro dealer replace damaged parts.
• Check that detachable tips fit good.
• Check that the pin locks when fully engaged. (as shown in Fig. 10)
8.5.13 Accessories
• Check the accessories for damage, dirt and completeness. Replace damaged accessories and
make sure that the accessories are complete.
• Remove dirt with clean running water. Dry the accessories and apply preservative oil to the
untreated steel surfaces.
8.6 Yearly dealer maintenance
We recommend having the equipment inspected, checked, set and tested once a year by a Holmatro
Certified Technician who has the appropriate knowledge and the necessary tools (see also section 1.7).
The Holmatro dealer can organize the yearly maintenance for you on a contract basis.
CT51** (RH)(ST) 916.001.554_004
EN
49