Test Mode - Honeywell 8010 Bedienungs- Und Installationsanleitung

12.7 Test mode

The automatic zones (1-8) can be switched to Test mode via the function keys and the ten-button keypad of the
control panel. For operation, the keypad must be enabled via the key switch.
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
Extra releasing 1
locked
Outputs
Alarm
Fig. 11: Operation example – Activating the Test mode, detector zone No.6
The zone input in Test mode is indicated in the zone display with a yellow/red flashing LED. The yellow LED
>Test Mode< also lights up to indicate that the zone display is showing the status of the detector zone.
Press the following key combination to activate and reset the detector zone:
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
locked
Extra releasing 1
Outputs
Alarm
Fig. 12: Operating example – Deactivating Test mode, detector zone No.6
FB 798352 / 11.07
Extinguishing Control Computer 8010 - Series 2
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Zone
6
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Zone
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
On
6
Test operation
Extra releasing 1
Outputs
Alarm
Detector zone
1 2 3 4 5 6 7 8
9 10 11 12 13
Fire/Switch off/Trouble
73