Installation; Aufliegenden Einbau - Küppersbusch KMI8500.0 Bedienungsanweisung Mit Montageanweisungen

Installation

Variable installation possibilities:
For installation, choose between:

Aufliegenden Einbau

830
4
R5
750+1
2
min.50 1
Insert the hob and align it.
1 Minimum clearance to adjacent walls
2 Cut-out dimension
3 Recess dimension
4 Outer dimensions of hob
Flush installation
834+1
3
R7
750+1
2
1
min.50
Glue the sealing tape onto the corner of the supporting edge of the
worktop so that no silicone adhesive can be pressed under the hob.
Place the hob into the worktop cut-out without any adhesive and align
it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-resistant
silicone adhesive.
4
2
4
1 min.50
3
3
2
1
min.50
84 x 455
3
84 x 455
Important
Silicone adhesive must not get pressed anywhere under the sup-
porting surface of the hob. If this occurs it will not be possible to
remove the hob again at a later stage. No liability will be assumed in
the case of failure to observe these instructions.
GB
39