Falcon Excel 110 Gebrauchsanleitung Seite 21

Single phase
Three phase
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type, as above. Check that the links are correctly
fitted and that the terminal screws are tight. Secure the
mains cable using the cable clamp.
Hob Check
Check each ringed area in turn.
Oven Check
Set the clock as described earlier in the instructions, and
then turn on the ovens. Check that the oven fans start
to turn and that the ovens start to heat up. Turn off the
ovens.
Fitting the Plinths
Fit the inner plinth to the bottom front of the cooker using
the five screws provided.
Fit the outer plinth (two screws, one each end) to the
inner plinth. The height of the outer plinth can be
adjusted by sliding it up or down via the slotted hole.
Check the appliance is electrically safe and gas sound when you have finished.
INSTALLATION
Please complete your contact details in the front
of this section, and then, having ensured that the
user know how to operate the cooker, hand over the
instruction pack. Thank you.
Servicing
Disconnect the cooker from the electricity supply
before commencing servicing, particularly before
removing any of the following: control panel,
side panels, ceramic hob, or any of the electrical
components or cover boxes.
Prior to reconnection, check that the appliance is
electrically safe.
1 To Remove the control panel
Disconnect from electricity supply.
Pull off all the control knobs.
Open the grill and right hand oven doors and remove the
three fixing screws underneath the control panel.
The control panel should drop down slightly. It is held at
the top by two holes in the top edge, one at each end,
that locate on tags on the inner panel.
Clear the control panel holes from the inner panel and
pull the control panel forward.
Disconnect the wiring from the rear.
Reassemble in reverse order. When replacing leads, refer
to the wiring diagram in this manual. Check the operation
of the timer.
2. To Remove a Side Panel
Disconnect from electricity supply.
Remove the control panel (see section 1). Pull the cooker
forward. Remove the four retaining screws for each panel
21