Removing And Installing The Rotor - Hettich EBA 280 Gebrauchsanweisung

Operation
6.2

Removing and installing the rotor

Removing a rotor with a
release knob
Fig. 18: Rotor installation and
removal
1 Release knob
2 Motor shaft
Installing a rotor with a release
knob
Removing a rotor without a
release knob
Fig. 19: Rotor installation and
removal
1 Handle
2 Motor shaft
20 / 44
Close the lid and press the front edge of the lid down gently.
�� The lid locks using a motor.
'Lid locked' indicator appears.
The
Personnel:
■
Trained user
1. Open the lid.
1
2. Pull the release knob (
2 ).
shaft (
2
Personnel:
■
Trained user
The lid is open.
1. Clean the motor shaft (
2. Lightly grease the motor shaft (
cleaning and disinfection' on page 35 .
3. Lift the rotor by the release knob (
motor shaft (
�� The rotor engages automatically on the motor shaft.
4. Check that the rotor is firmly seated by holding the rotor on the left
and right and pulling up gently.
Personnel:
■
Trained user
1. Open the lid.
1
2. Hold the rotor by the handle (
2
Rev.: 07 / 10.2023
1 ) up, hold it and lift the rotor off the motor
2 ) and rotor hole.
2 ), see ⮫ Chapter 8.2 'Instructions for
1 ) and place it vertically on the
2 ).
1 ) and lift it off the motor shaft ( 2 ).
AB1101en