Christopeit Sport TM 750S Montage- Und Bedienungsanleitung Seite 21

Meanings o error message codes
In case o malunctions may adjoining list o error messages help
or savvy people to get unction back. Basically, electrical repairs
only in compliance with the relevant saety rules which exists. For
more inormation and assistance in case o malunctions with our
service department (contact details see last page.)
Problem Potential reasons
---- The saety lock is removed
E01 Communication abnormality: abnormal
communication between the controller
and the electronic meter ater powering
on.
E02 Voltage-proo protection:
E03 No sensor signal:
E05 Over-current protection:
E07/E08 EEPROM deect
Motor The motor cable is damaged or con-
will not nected incorrectly.
start The use on the control board has been
damaged or dropped.
The control board is deect.
The motor is deect.
Remind add oil unction
When the treadmill in running sate, the total distance more than
100KM, the time windows will show time and OIL take turns, and
have the buzzer sounds, it reminds the user need add the oil. At this
state, press [STOP] button can eliminate the reminder and zero the
cumulative distance. In addition, pull out the saety key, press the
[EINGABE] and [PROG] more than 3 seconds will show cumulative
distance. I you want eliminate, press the [EINGABE] and [PROG]
more than 3 seconds again.
Training area in mm
(or home trainer and user)
Solutions
1. Put the saety clip in position
2. Change the saety clip or saety clip socket at computer.
3. I it's still not ok, than change the computer.
1. Switch o the treadmill and plug out AC cable.
2. Check each section o communication cables rom the electronic meter to the controller and
ensure that all cables are well connected.
3. Check whether cables between the electronic meter and the controller are damaged; i yes,
replace the damaged wire.
1. Switch o the treadmill and plug out AC cable
2. Check whether the power supply voltage is less than 50% o the normal value. Please en-
surecorrect voltage and test again.
3. Check whether the controller emits the odor o burning; i yes, replace the controller.
4. Check whether motor cables are well connected; re-connect motor wires.
1. Switch o the treadmill and plug out AC cable.
2. Check whether the sensor cable is well plugged or whether it is damaged; plug it well or
replace the sensor.
1. Check whether power supply voltage specications is inconsistent or too low and use correct
voltage specications or re-test.
2. System sel-protection is triggered under excessive current caused by the excessive load
more than the rated value, or some place o the treadmill is jammed so that the motor cannot
rotate; thus, the system start up sel-protection against excessive current under excessive
load; adjust the treadmill and restart it.
3. Check whether there is over-current sound or burning odor when the motor is running;
replace the motor.
4. Check whether the controller emits abnormal odor; replace it i yes.
Replace the control board.
Check the motor cable.
Check the use. Reinsert it, or replace the use.
Replace the control board.
Replace the motor.
Hibernation
I the treadmill is not in use the display switch o into Standby Mode.
Free area in mm
(Training area and security area
(rotating 60cm))
21