Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.6
Disassembly and disposal
2.6.1
Safety
Basics:
WARNING!
Risk of injury through improper disassembly!
Personnel:
· Disassembly must only be carried out thoroughly trained and experienced specialists.
· Work on the electrical system must only be carried out by electricians.
Electrical systems:
DANGER!
Danger to life from electric current!
2.6.2
Disassembly
Before beginning the disassembly:
· Switch off the system and secure against being switched on again.
· Physically disconnect the entire power supply from the equipment and discharge stored residual energy.
Then professionally clean modules and components and disassemble in accordance with accepted local safety at work and en-
vironment protection regulations.
2.6.3
Disposal
If no take back or disposal agreement was made, take disassembled component parts to the recycling depot:
· Dispose of metallic residual component parts as scrap metal.
· Take plastic parts to the recycling depot.
· Sort and dispose of other components according to the properties of the material.
CAUTION!
Damage to the environment from improper disposal!
Local authorities and specialist disposal companies can provide information on environmentally compatible disposal.
52
Stored residual energies, components with sharp edges, points and corners of individual components or on
the required tools can cause serious injury.
For this reason:
· Before beginning the work, make sure there is sufficient space for installation.
· Be careful with open, sharp-edged components.
· Ensure orderliness and cleanliness at the installation location! Loose components and tools that are lying
on top of one another or scattered about are sources of accidents.
· Professionally disassemble components in compliance with applicable local regulations.
· Always secure components in such a way that they cannot fall down or fall over.
· If you are uncertain, please contact the manufacturer.
Contact with live components results in danger to life.
Switched-on electrical drives can cause components to go into uncontrolled motion and cause very serious
injuries.
For this reason:
· Before beginning disassembly, switch off the electrical power supply.
· Disconnect all connections from the mains.
Electronic scrap, electronic components, lubricants and other auxiliary substances are liable to treatment as
hazardous waste and must only be disposed by approved specialised companies!
297134-12-DE-EN_2023-02
Dockingstation - Warntafel - Anprallkissen
© 2023 Adolf Nissen Elektrobau GmbH + Co. KG
ENGLISH
Werbung
