Operation - Wolf Garten Campus 250 RT Originalbetriebsanleitung

z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF cord
spools and note the installation instructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed ser-
vice centres or by the manufacturer.
z Make sure all air holes are free of dirt.

Operation

Operating times
z Please check noise abatement regulations
prevailing in your country.
Assembly
A B C
z See illustrations.
Insert power cable into cable holder
The power cable holder in the guide grip prevents
accidental disconnection of the extension cable
D E
.
Connecting to the mains (230 Volts,
A.C., 50 Hz)
z The mower operates from any normal
household mains supply, provided with a 16
Amps. fuse.
3
Note: Residual current protection
device
These protection devices safeguard
while touching damaged wires, from
insulation flaws and in certain cases, also
while damaging live wires.
z We recommend that the equipment
only be plugged into a power socket,
which is protected by a residual
current protection device (RCD) with a
residual current of not more than
30 mA.
13
z Do not store the unit within reach of children.
Disposal
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equip-ment, accessories and packa-
ging in an environment-friendly man-
ner.
z
Retrofit kits are available for old instal-
lations. Consult an electrician.
Working position
The optimal operational gradient for edging and
free-cutting is approx. 30°. For free cutting (no
ground contact) swing device in a semicircle be-
fore your body.
On / off switch
F
Thread adjustment
The thread is adjusted with the tilt switch. Briefly tilt
the running machine on a firm base, e. g. paving
slab (approx. 3 kg pressure). Approx. 1,5 cm cut-
ting thread are the automatically paid out..
3
Tips on trimming
z Cut high grass slowly, step by step.
z If the cutting cord becomes too short due
to normal wear, simply switch off the
trimmer. The cord will then automati-cal-
ly adjust to the correct length.
z Whenever the trimmer is switched off
and then on again, the cord automatical-
ly lengthens 6-8 mm. If the trimmer is fre-
quently switched on and off for no rea-
son, this will increase wear of the cord.
z You can prolong the life of your trimmer
by removing grass from the ventilation
slots and the bottom of the trimmer be-
fore or after each use.
F G
H
G